Getting Started with KMS USB

Congratulations on receiving your USB Microcomputer interface and Contact Mat with Kinematic Measurement System Software. Here are the steps to getting up and running – literally!

KMS USB Arduino Interface 300x225 Getting Started with KMS USB

  1. If you have not already done so Download and Install the KMS Software.
  2. Plug the KMS USB Interface into a USB port of your computer. It will flash green three times when it starts up.
  3. Plug in the contact mat.
  4. Run the Kinematic Measurement System. There are lots of instructional videos on how to use the KMS…

Any problems? Please see our Frequently Asked Questions section, check out our Instructional Video or contact Innervations Support.